Thread Protector for Sauer 90 in. 270 Winchester

Started by gitano, September 04, 2023, 04:50:07 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

gitano

All of Alain's rifles were fitted with supressors. Since getting a supressor in the US is 'difficult', no suppressors came with any of his rifles. Instead, they were all fitted with muzzle brakes.  I don't like muzzle brakes. I don't like what they do - make muzzle blast uncomfortably loud for the shooter and those nearby, AND, to my eye, they're ugly. Sauer 90s come with muzzle brakes standard. The 90 I have in .338 Win Mag has one, and so does the .270. So I decided to make a thread protector for the .270.

PXL_20230905_001114196~2.jpg

As usual, the camera exacerbates microscopic lines in metal.  :stare: It looks better than the picture looks. One thing I don't like about thread protectors is that with the barrel heating up and expanding and contracting, they can get stuck on. In order to combat that the DoD puts "compression washers" between the flash supressors on M14s (AR-15s) and the shoulder of the threaded muzzle. I decided to just put an O-ring. I also milled a couple of flats in it so I can take a wrench to it if I need to.

I'm going to make one for the .338 next. Then work my way through all of Alain's rifles.

I 'colored' it in the kiln - 20 minutes at 650F - but I think I'm going to use some Birchwood Casey bluing to try and darken it a bit more.

Paul

Be nicer than necessary.

Tags: